3
(1) Mount the remote controller onto the rear case mounted on the mounting bracket in
(2) Mount the remote controller panel onto the upper cabinet.
4
Pull out the remote controller wiring through the notch in the top part of the foam cover.
Fix the foam cover using the screws unfastened in
5
Mount the upper cabinet.
Connect the remote controller wiring to the terminals A and B of the electrical control box.
*For the details, refer to the "7 Electrical connection" in this Installation Manual.
119-EN
2
. (2).
1
. (3).
Notch
Remote controller wiring
Foam cover
Fixing screws (2 pieces)
<RBC-ASCU1 >
This remote controller cannot be attached to the main unit. This remote controller is used by mounting it on a wall
etc. Purchase and attach a Cover kit (sold separately) to the remote controller mounting part of the main unit.
REQUIREMENT
If you do not want to attach the remote controller to the main unit, install the Cover kit TCB-CKC1F-E (sold separately).
Follow the steps below to install the Cover kit.
Upper cabinet
Screws fastening
upper cabinet
(2 pieces)
Cords (2 pieces)
Intake grille
1
Removing the remote controller panel
1) Untie the cords of the air inlet grille and remove the air inlet grille.
2) Unfasten the two screws fastening the upper cabinet. Lift up the upper cabinet and remove it.
3) Unfasten the two screws fastened on the back of the upper cabinet and remove the foam cover.
4) Push out the remote controller panel through the back of the upper cabinet and remove it.
5) Give the removed remote controller panel to the user and ask them to keep it together with the Installation
Manual.
2
Installation of Cover kit
1) Attach the Cover kit to the position of the remote controller panel removed in 4) of
2) Attach the foam cover to the upper cabinet using the two screws from 3) of
3) Attach the upper cabinet and intake grill to the main body by reversing the procedure of
– 60 –
Foam cover
Remote controller panel
Pins (4 pieces)
Screws fastening foam cover (2 pieces)
1
above.
1
above.
1
above.
120-EN