Internal Cleaning; Cleaning The Spray Arms; External Cleaning; Troubleshooting - Progress PVX1550 Benutzerinformation

32 Progress
CAUTION! An incorrect position
of the filters can cause bad
washing results and damage to
the appliance.

Cleaning the spray arms

Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.

External cleaning

• Clean the appliance with a moist soft
cloth.

TROUBLESHOOTING

If the appliance does not start or it stops
during operation, before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The end indicator flashes 1 time in-
termittently.
• Acoustic signal sounds 1 time inter-
mittently.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.

Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a soft
moist cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.
With some problems the end indicator
flashes intermittently indicating a
malfunction.
Possible solution
• Make sure that the mains plug is connected to
the mains socket.
• Make sure that there is no a damage fuse in the
fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait
for the end of the countdown.
• The appliance has started the procedure to re-
charge the resin inside the water softener. The
duration of the procedure is approximately 5 mi-
nutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply
is not too low. For this information, contact your
local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.