Veripart VPKK143W Benutzerinformation Seite 58

PROBLEM
There is too
much frost
and ice.
The
compressor
works
continuously.
The lamp does
not work.
The side panels
are hot.
Contact the service centre if the fault occurs again.
POSSIBLE CAUSE
- The door is not closed properly.
- The door gasket is deformed or
dirty.
- The products are not packed
correctly.
- The temperature is set
incorrectly.
- The appliance is fully
loaded and set to the lowest
temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- The temperature is set
incorrectly.
- Many products are placed at the
same time.
- The room temperature is too
high.
- The food placed in the
appliance was too hot.
- The door is not closed properly.
- The lamp is broken.
- The lamp is in the standby
position.
- This is normal. The heat
exchanger components are on
the side.
SOLUTIONS
- Find the cause of the door
not closing properly, remove
or move possible obstacles.
- As a result, the door does
not close properly. Clean
the seal and repair the
deformation. If necessary,
replace the seal, contact
customer service.
- Pack the products better.
- Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
Set a higher temperature.
Please refer to Section 4.
- Please refer to Section 4.
- Wait a few hours and then
check the temperature
again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the previous section.
- Please contact our customer
service.
- Close and open the door.
58