Technical Data; Symbols - Stiga SHT 700 Gebrauchsanweisung

IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS
Maximum noise and vibration levels [1]
Sound pressure level (EN 60745)
– Measurement uncertainty
Guaranteed sound power level (2000/14/EC)
Vibration level (EN 60745)
– Measurement uncertainty
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other elec-
tric equipment as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indi-
cated. Safety measures must be established to protect the user and must be based on the load estimate generated by the vi-
brations in real usage conditions. In this regard, all the operational cycle phases must be taken into consideration, such as switch-
ing off or idle running.

TECHNICAL DATA

Power supply voltage
Power supply frequency
Engine Power
Cutting lenght
Cutting movements
Mass

2. SYMBOLS

1 2
1) If you are using the machine every day in nor-
mal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safetyglas-
ses and hearing protection.
2) Warning! Danger. Failure to use this machine
correctly can be hazardous for oneself and o-
thers.
3) Read the instruction manual before using the
machine.
3 4
4) Disconnect the plug from the mains before
commencing maintenance work or if the power
cord is damaged.
5) Do not leave the machine in the rain (or in damp
conditions).
6) Warning! Danger! Sharp blade. Risk of injuries.
SHT 700
dB(A) 85.2
dB(A) 3
dB(A) 97
m/s < 2.5
2
m/s 1.5
2
SHT 700
V~ 230-240
Hz 50
W 700
cm 67
min 2400
-1
Kg 4.2
5 6
3
EN