Introduction
These operating instructions provide important information on the
correct installation and operation of the gas alarm. Please read the
instructions completely and carefully before installation.
operating instructions belong to this product and contain important
points concerning bringing the appliance into service and its
operation.
Always pay attention to all safety instructions. Should you have any
questions or be unsure about operating the appliance ask a
specialist.
Keep the instructions and pass them on to third parties as
necessary.
Intended use
The CO 90 is designed to detect carbon monoxide. It is intended for
use in private homes.
The design is based on a type A device - to emit a visual and acoustic
alarm and trigger an output signal which, in turn, directly or indirectly
activates the ventilation or triggers other auxiliary equipment.
The CO alarm is designed to be connected to a supply voltage of
230 V AC / 50 Hz. A mains cable attached to the device is used to
connect to the mains. As a separate model, the CO alarm is available
for an operating voltage of 12 V DC. The electrical connection for this
model is made via a 2-pole connecting terminal. The CO alarm must
not be used in rooms with potentially explosive atmospheres and is
not a primary measure of protection against explosions in accordance
with the guidelines of the Accident Prevention & Insurance
Association.
Attention:
!
Under certain circumstances, this carbon monoxide alarm may not
provide adequate protection to persons who because of their age,
because of pregnancy, or because of illness are especially
GB
susceptible to the effects of carbon monoxide. If in doubt, ask your
GP.
!
Devices designed to detect carbon monoxide are not a substitute
for the correct installation and regular maintenance of fuel-fired
equipment or regular chimney cleaning and maintainance
The
thereof!
This carbon monoxide alarm is not suitable for use as a smoke
alarm or as a de a detector of combustible gases!
Scope of delivery
!
CO 90
!
2 x fixing screws used for installation
!
2 x fixing plugs
!
Installation and Operating Instructions
Description
CO-ALARM
CO90
2
3
4
EN 50291-1:2018/AC:2021
5
11
1
6
ALARM
POWER
TEST
EINGANG
RELAIS
12-VOLT
12 V DC
AUSGANG
AUSGANG
8
9
10
7
11
- 27
GB