Maintenance; Protecting The Environment - DeWalt D28700 Originalanweisungen

• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Proper Hand Position (fi g. F)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the
main handle (35), with the other hand guiding the
workpiece.
Performing a cut (fi g. A)
• Place the material to be cut against the fence (8)
and secure using the material clamp (7).
• Switch on the tool and pull down the control
handle (2) to cut the workpiece. Allow the motor
to reach full speed before cutting.
• Allow the disc to cut freely. Do not force.
• After completing the cut, switch off the tool and
return the arm to its upper rest position.
Switching on and off (fi g. A)
The on/off switch (1) is mounted in the operating
handle (2).
• To run the tool, press the on/off switch (1).
• Keep the on/off switch depressed while
performing the operation.
• To stop the tool, release the switch.
Do not switch the tool on or off when
under load.
Do not cut magnesium.
Consult your dealer for further information on the
appropriate accessories.
Transporting (fi g. A)
The tool is equipped with a lock-down pin (13) which
locks the tool in closed-down position for carrying.
• Lower the guard (4) onto the cutting table (10)
and secure the tool in this position by pushing in
the lock-down pin (13).
• Transport the tool using the carrying handle (3).
• To release the tool, depress the operating handle
slightly and pull out the lock-down pin (13).

Maintenance

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.

Protecting the environment

Separate collection. This product
must not be disposed of with normal
household waste.
Should you fi nd one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to
be recycled and used again. Re-use
of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
E N G L I S H
WALT product
E
31