Bosch GTM 12 JL Professional Originalbetriebsanleitung Seite 46

OBJ_BUCH-1688-005.book Page 46 Wednesday, June 17, 2015 9:11 AM
46 | English
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Bevel angle
Floor strip/moulding
Inner corner Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
Outer corner Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the standard mitre angles
52°
of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
38°
Settings
Bevel angle
Ceiling strip/moulding
Inner corner Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
Outer corner Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
1 609 92A 18Z | (17.6.15)
Always make trial cuts with the mitre angle setting first on
scrap wood.
Placed
against the
fence
0°
Left side Right side
45° left 45° right
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of the
cut cut
45° right 45° left
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of the
cut cut
Placed
against the
fence
52°
0°
Left side Right side
45° right 45° left
Bottom edge Bottom edge
against the fence against the fence
... to the right of the ... to the left of the
cut cut
45° left 45° right
Bottom edge Bottom edge
against the fence against the fence
... to the right of the ... to the left of the
cut cut
Lying flat on
the saw table
45°
Left side Right side
0° 0°
Upper edge against Bottom edge
the fence against the fence
... to the left of the ... to the left of the
cut cut
0° 0°
Bottom edge Upper edge against
against the fence the fence
... to the right of the ... to the right of the
cut cut
Lying flat on
the saw table
33,9°
Left side Right side
31.6° right 31.6° left
Upper edge against Bottom edge
the fence against the fence
... to the left of the ... to the left of the
cut cut
31.6° left 31.6° right
Bottom edge Upper edge against
against the fence the fence
... to the right of the ... to the right of the
cut cut
Bosch Power Tools