Cleaning And Maintenance; Description Of The Appliance - yuna FROSTER 300 Bedienungsanleitung

1. Remove all packaging materials.
2. Adjust the feet and clean the appliance; see also chapters « L
« C
LEANING AND MAINTENANCE
3. Do not start the appliance immediately after installation. Wait at least 4 - 5 hours
to ensure proper operation.
4. Connect the appliance to the mains properly.
5. The setting of the temperature of the freezer can be adjusted manually by pressing
the relevant button until the desired value is indicated on the temperature
indicator bar; s. chapter 4.5 S
M et seq.
ODE
6. The noise generated by the compressor and the gases / liquids of the appliance
is normal.
7. If operation was interrupted, wait 5 minutes before restart.
8. The appliance needs some time to balance temperature when you have changed
the settings before or when you have stored additional food in the appliance. The
duration of this period of time depends on the range of the change, the ambient
temperature, the amount of food and the frequency of door-openings. When you
set the temperature of the appliance, these aspects should be taken into account.
9. Due to the difference of pressure, the door may be difficult to open shortly after
closing. Wait a few minutes and you can open the door easily.
10. Operate the appliance according to the instructions described in the following
chapters.

4.2 Description of the appliance

».
ETTING OF THE TEMPERATURE
Fig. similar: modifications are possible.
» and
EVELLING
/ F F
AST REEZING
59