Configuration Of The Two Yokis Buttons; Configuration Via The Yokis Pro App; Configuration Without The Yokis Pro App; Direct Mode - urmet MIRO VIVAVOCE YOKIS 1750/15 Bedienungsanleitung

To end the conversation, shortly press
7.

CONFIGURATION OF THE TWO YOKIS BUTTONS

7.1. CONFIGURATION VIA THE YOKIS PRO APP

The video housephone
Installer App. It is possible to configure its two Yokis buttons using the app and download the configuration
to the video door phone, following the standard procedure (pressing one of the two buttons twice).
Button corresponds to channel 1,

7.2. CONFIGURATION WITHOUT THE YOKIS PRO APP

Alternatively, the two Yokis buttons can be configured without using the YOKIS PRO app: the two buttons
can be set up as a two-button Yokis remote control.

7.2.1. DIRECT MODE

1 - Briefly press the button you want to connect 5 times (**) (E5).
The LED on the video door phone will start flashing for 30 seconds, indicating that a connection is
waiting.
(**) Each pressure must be faster than 0.7 seconds long.
2 - While the video door phone LED is flashing, press briefly with the tip of a pencil into the "connect" hole
of the receiver (R) (located at the front or back of the receiver).
The LED on the video door phone will stop blinking.
Important: The receiver must be powered.
On the video door
phone, the
LED lights up
only if the radio
transmission
was successful.
To cancel a connection, simply repeat the same procedure.

7.2.2. CENTRALISATION IN DIRECT MODE

A control can be centralised by repeating the same procedure on up to four receivers per button. In
addition, use the Radio Bus.

7.2.3. RADIO BUS MODE

It is possible to connect an unlimited number of receivers to each other, thus creating a "Bus Radio". This
can be used to:
• send controls to groups of receivers on the radio bus (see "Yokis Radio Quick Installation Guide");
• send a control from the video door phone to a receiver which is out of direct range;
• centralise the control of all lights or of all shutters or of all lights and shutters together. All Yokis receivers
are Bus Radio compatible.
DS1750-014C
button.
hands-free Ref. 1750/15 or 1750/16 is perfectly integrated in the YOKIS PRO
button to channel 2.
1
2
15