Adjusting Anti-Tipping; Mounting Or Removing The Push Bar; Push Handle Height - Vermeiren V300DL Gebrauchsanweisung

EN
NL
3.5

Adjusting anti-tipping

3.6

Mounting or removing the push bar

WARNING
 Make sure that buttons Ⓐ are tightened.
 When equipped with the push bar, the push bar should always be mounted to increase the
stability of the back.
To mount the push bar:
1. Mount the push bar Ⓑ with the star knob Ⓐ in the left handgrip.
2. Swing the push bar Ⓑ to the right.
3. Mount hook Ⓒ over the right handgrip Ⓓ as shown on the drawing. Use holes  or  to
adjust the tension of the backrest.
To take off the push bar:
1. Loosen the star knob Ⓐ on the right handgrip.
2. Remove hook Ⓒ from the right handgrip Ⓓ.
3.7

Push handle height

The push handles can be adjusted steplessly over a distance of 60
mm:
1. Loosen the screw (1) .
2. Move the handgrip up/down to the desired height.
3. Retighten the screw (1) .
4. Repeat for the other handle. Make sure that both handles are
firmly secured.
Adjust the height of the anti-tipping in 7 positions (range 120 mm:
steps 20 mm):
1. Loosen the star knob (1) a little bit.
2. Move the tube of the anti-tipping in the desired height.
3. Secure the star knob (1).
4. Make sure that the anti-tipping is firmly secured.
Risk of injuries
10
V300DL
2022-05
Using your wheelchair
1