Parts Description; Before The First Use - Princess SMART Bedienungsanleitung

• Take care to ensure that the feet are located
correctly on the bottom end of the heater.
• The heater should stand vertically once the
feet are installed (image 3). If the heater tilts
backwards then please remove the feet and
rotate them before fitting again. (image 4)
Wall mounting
• Demount the bracket from the back of the
device, by loosening the screws.
• Please note that the product must be
installed at least 15 cm from the floor and 50
cm from the ceiling.
• Install the bracket with the provided screws.
(image A)
• Drill the holes in the wall on each side, then
insert the plastic expanded plugs and fix the
bracket in the wall with the screws provided.
(image B)
• Place the heater in a suitable position and
ensure that the holes are aligned with the
bracket. (image C)
• Tighten the screws on top of the bracket.
(image D)

PARTS DESCRIPTION

1. On / Off switch
2. Display
3. Touch button control panel
4. Heater
5. Feet
6. Wall bracket

BEFORE THE FIRST USE

• Place the device on a flat stable surface and ensure a minimum
of 15cm free space around the device. This device is not suitable
for installation in a cabinet or for outside use.
• When the device is turned on for the first time, a slight odour will
occur. This is normal, ensure adequate ventilation. This fragrance
is only temporary and will disappear soon.
• During heating up and cooling down there may be some noises
caused by the heater casing expanding and contracting, this is
normal and does not indicate any fault.
Instruction manual
EN
5