Suction Function; Before Starting - Meec tools 021332 Bedienungsanleitung

EN
4. Tighten both screws.
FIG. 4
Fit blowpipe 2 on blowpipe 1.
5. Align blowpipe 2 (8) to the tap on
blowpipe 1 (7) and put on the pipe.
6. Turn the pipe 90° clockwise to lock it.
7. Tighten the screw.
FIG. 5
NOTE:
• The product is supplied with two sets of
tubes, one for blowing and the other for
suction. They are attached in the same way.
• When correctly attached the flat part of
the tube points to the ground.
• The blower function will not work unless
the blowpipe is attached.

SUCTION FUNCTION

Fit the suction tube 1 on the
engine unit
1. Press in the pin on the suction sleeve cap
and pull up the cap.
FIG. 6
2. Align the four slots on the suction tube 1
(10) to the corresponding holder on the
engine housing.
3. Put the tube on the engine housing and
lock by turning it 90° anticlockwise.
FIG. 7
Fit the suction tube 2 on suction
tube 1
1. Align suction tube 2 (9) to the tap on
suction tube 1 (10) and put on the pipe.
2. Turn suction tube 2 clockwise 90° to lock it.
3. Tighten the screw.
FIG. 8
42
Attach the outlet tube and bag
1. Remove the retaining screw from the air
outlet.
2. Align the mounting lug to the holder on the
air outlet and push the outlet tube in place.
3. Tighten both screws.
4. Put the end of the end of the outlet tube
in the bag and close the opening with the
supplied band.
FIG. 9
5. Fit the harness by hanging the strap over
the shoulder and adjusting the height
with the band.
FIG. 10
NOTE:
When correctly attached the bottom part of
the tube points down and to the left of the
user and the round part of the tube points
down to the ground.
USE

BEFORE STARTING

Check the following points before starting the
engine:
• That all screw unions and other
connections are correctly attached.
• That the bag is correctly attached and
closed, and that the zip works properly
(only applies to suction function).
• That the air filter is clean. Clean if necessary.
• That the handle is correctly and securely
attached.
• That the accessory for the function in use
(blower or suction function) is correctly
attached.
• That there is enough fuel.
FUEL
• The product has a 2-stroke engine, which
takes premixed fuel of petrol and 2-stroke oil.