Cleaning And Maintenance; Replacing The Lamp - Klarstein CLARA Bedienungsanleitung

CLEANING AND MAINTENANCE

Switch off the extractor hood and pull the plug out of the socket before cleaning
and maintenance. The outer surfaces are susceptible to scratches and stains.
Therefore, do not use scouring agents for cleaning and wipe away residues of
alkaline or acidic substances (lemon juice, vinegar) immediately after cleaning.
Stainless steel surfaces
The stainless steel must be cleaned regularly to ensure a long service life. Use
stainless steel cleaner for this purpose. Always wipe along the grain of the
stainless steel to prevent criss-crossing scratch marks.
Control panel interface
The control panel can be cleaned with a damp cloth and mild dishwashing
detergent. Before cleaning, make sure the cloth is clean and well wrung out. Use a
dry, soft cloth to remove excess moisture after cleaning.
Monthly cleaning of the grease filters
Clean the filter every month to avoid a fire hazard. The filter collects grease, smoke
and dust and thus influences the efficiency of the cooker hood. If the filter is not
cleaned, grease residues will collect there. Clean the filter with water and a little
washing-up liquid and let it air dry afterwards.

REPLACING THE LAMP

Important instructions for replacing the lamp
• The bulb must be replaced by the manufacturer, its after-sales service or a
similar person.
• Before replacing the bulb, make sure that the appliance is switched off and
the mains plug has been removed from the socket. When handling light bulbs,
make sure that they have cooled down completely before touching them.
• When changing the bulb, wear gloves or hold the bulb with a cloth to ensure
that no sweat comes into contact with the bulb, as this can shorten the life of
the bulb.
EN
35