Troubleshooting - Klarstein ALBARON Bedienungsanleitung

TROUBLESHOOTING

1. Please note, if a power failure occurs due to disconnection of the power cord,
or the power button has been pushed off during an ice making cycle, small
ice chips may formed and lodge in the automatic shovel causing it to jam. If
this occurs, the ice chips may be removed by disconnecting the power cord
and gently pushing the shovel to the rear of the cabinet and removing the ice
chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove
the ice to ice basket. If not, please push the ice shovel gently by finger, then
press POWER button to restart.
PROBLEM
The compressor works abnormally
with a buzzing noise.
Water shortage indicator light
is on
Indicator lights on control panel
are not on.
The ice made is too large and with
pieces sticking together.
The ice making process was cor-
rect, but no ice came out.
All indicators twinkle simultane-
ously.
The machine has been working,
but the water has been warming.
When the ice is full, the machine
does not display the ICE FULL Icon
POSSIBLE CAUSE
The voltage is lower than recom-
mended.
1.There is no water.
2.The pump is full of air.
Blown fuse/ No power
Ice of previous cycles left in the
water tray
1. The compressor has no refriger-
ant
2. Compressor damaged
3. Fan motor damaged
1. Water tray is blocked by ice
cube.
2. The motor is stuck, or the
motor falls off, or the motor is
damaged.
3. Micro switch is damaged.
Solenoid broke down
1. Ice full sensor damaged
2. Sunlight interference
SUGGESTED SOLUTIONS
Stop the Ice maker and do not
restart until the voltage is normal.
1.Add to some water until it
reaches MAX position.
2.Press POWER button to restart.
Replace fuse. / Turn power on.
Take out the ice under the standby
state.
Call the service hotline.
1. Unplug the power to take out
the ice which blocking the tray,
then plug the power and press the
POWER button, the machine will
restart 3minutes later.
2. Call the service hotline.
Replace the solenoid valve.
1. Replace the ice full sensor.
2. Making ice indoor.
3. Call the service hotline.
EN
23