Start/Stop The Leaf Blower - Fuxtec FX-LB126 Original Bedienungsanleitung

Original-Bedienungsanleitung FUXTEC Laubbläser/-sauger FX-LB126/LBS126_de_en_fr_ita_rev07
32.

Start/stop the leaf blower

The device must not be put into operation until you have read this operating manual,
observed all the instructions given and the device had been completely and correctly
installed!
•
Only start the device when it is completely assembled.
•
Support the device on the ground for starting and hold it firmly.
1. Maintain a distance from flammable materials.
2. Take a safe standing position.
3. Place the device on the ground in front of you
4. Hold the device by the upper bracket with your left hand
5. Grasp the pull starter with your right hand
Starting with cold engine
1. Slide the ON / OFF switch 2 to position 1.
2. Gently press the primer pump below choke lever 5 several times until fuel enters the pump.
3. Push the starting lever 5 (choke) to
4. Pull out the starting cord 7 at the
5. Pull quickly on the start cord and then release it slowly.
Do not pull out the starting cable completely and do not let the starting handle snap back
on the engine.
6. Push the starting lever (choke) to
started
7. The engine rotates in idle speed
8. Before starting work, let the appliance warm-up at idle for about 2-3 minutes and slowly start to
pull the throttle lever 2.
9. For continuous operation, use the speed-lock lever 16, which allows you to use the desired
engine speed without having to push the throttle firmly.
Stop the engine
1. Release throttle 2.
2. Set the ON / OFF switch to position 0
Starting with a warm engine
1. Move ON / OFF switch 2 to position 1.
2. Push the start lever (choke) to
3. Pull the starting cord on the starting handle until the engine starts.
starting handle slowly until resistance is reached.
approx. 20-30sec. after the engine has
36