Balluff BIS C-60 3 Serie Handbuch Seite 84

C60_3-025_825645_1310_e.p65
67
Configuration of the
input buffer for one
read/write head
(Example shown for
Head 1)
Description of
Input Buffer
Please note the
basic procedure on
70 and the
examples on pages
73...76.
68
Description of
Input Buffer
(continued)
Please note the
basic procedure on
70 and the
examples on pages
73...76.
68 english
Function Description
Mode 2: Input buffer, configuration and explanation
Bit No. 7 6
Subaddress
00 = Bit Header BB HF
Hex
01 Error Code
Hex
02
Hex
03
Hex
04
Hex
05
Hex
06
Hex
...
Last byte:
Input length 1
Sub- Bit Meaning
address Name
00 BB Ready
Hex
Bit Header HF Head Error
IN/KN
(continued on next )
Function Description
Mode 2: Input buffer, configuration and explanation
Sub- Bit Meaning
address Name
00Hex (continued)
Bit Header IN Input
KN Input
AF Command Error
AE Command end
AA Command start
CP Codetag Present Data carrier present within the active zone of the
Sub- Meaning Function Description
address
01Hex Error code Error number is entered if command was incorrectly processed
or aborted. Only valid with AF bit!
00Hex No error.
01Hex Reading or writing not possible because no data carrier is present
in the active zone of a read/write head.
02Hex Read error.
03Hex Data carrier was removed from the active zone of the read/write
head while it was being read.
04Hex Write error.
05Hex Data carrier was removed from the active zone of the read/write
head while it was being written.
(continued on next )
5 4 3 2
IN/KN AF AE AA
or
Data
Data
Data
Data
Data
Data
Data
Function Description
The BIS Identification System is in the Ready state.
Cable break from read/write head or
no read/write head connected.
Use same bit in the bit header. Either IN or KN can be
displayed. Therefore you must select either DigIN_Mode
= 1 or HS_LS_Mode = 1 (see 18).
Function Description
If the parameter "DigIN_Mode" is 1 and parameter
'HS_LS_Mode' is 0, this bit indicates the state of the
Input.
If parameter DigIN_Mode = 0 and HS_SL_Mode = 1,
this bit indicates the selected head.
0 = Head X.1, 1 = Head X.2
The command was incorrectly processed or aborted.
The command was finished without error.
The command was recognized and started.
read/write head.
1 0
CP Bit Name
Data
67
english