Wolkenstein WGSP15-8FI Bedienungsanleitung Seite 167

P
OSSIBLE CAUSE
S
OME DETERGENT IS LEFT IN THE CONTAINER
1. Dishes block the container of the
detergent
1. Normal.
B
LACK OR GREY SPOTS OR RUST SPOTS ARE ON THE TABLEWARE
1. Aluminium-made objects touched
the dishes.
2. The items
resistant.
3. The lid of the water softener
container is not close properly.
4. You have not started a programme
after you added the water softener.
The remaining water softener is now
affecting the running programme.
W
ATER REMAINS ON THE BOTTOM OF THE APPLIANCE
1. Normal.
S
1. Extremely hard water.
2. Very low temperature of the water
supply.
3. The appliance is overfilled.
4. The dishes are placed improperly.
5. Old or wet detergent.
6. The rinse aid container is empty.
7. Improper detergent dosage.
( )
S
are not corrosion
POTS AND FILM ON GLASSES AND CUTLERY
E
RROR
1. Place the dishes properly.
S .
TEAM
1. There is some steam coming through
the vent near the door latch during
drying and water draining.
1. Clean the marks with a mild abrasive
cleaner by hand.
2. Do not clean such items using the
appliance.
3. Close the lid properly.
4. Always start the rapid programme
without adding any tableware when
you have added some water softener.
1. A small amount of clean water
around the outlet keeps the water
seal functioning.
1. Check the water hardness.
2. Check the temperature of the water
supply.
3. Do not overfill the appliance.
4. Always place the dishes properly.
5. Always use proper detergent.
6. Refill the rinse aid container.
7. Dose the detergent properly.
M
EASURES
.
.
.
.
~ ~
167