Backrest Inclination (Eclips X2 30° Kids); Mounting Or Removing The Push Bar (Eclips X2 30° Kids) - Vermeiren Eclips X2 Kids Gebrauchsanweisung

EN
NL
To install the footrest
1. Place the footrest (7) in the footrest support (29), holding the
footrest on the side of the wheelchair.
2. Swing footrest (7) inwards until it clicks in position.
3. Swing footplate (8) downwards.
4. Repeat for the second footrest.
5. Make sure that the footrests are firmly secured.
3.3 Backrest inclination (Eclips X2 30° Kids)
WARNING
 Be aware that the stability decreases when backrest is adjusted backwards.
 Apply the parking brakes before adjusting the backrest.
CAUTION
 Do not place your fingers, clothes between the adjustment mechanism.
For model Eclips X2 30° Kids, it is possible to set the backrest backwards with a maximum
inclination of 30° (4 different positions: steps of 10°). Make sure that the patient sits in the chair
when the attendant adjusts the backrest inclination and that the wheelchair does not tip over.
If your wheelchair features drum brakes, the handles  are
used as brakes.
3.4 Mounting or removing the push bar (Eclips X2 30° Kids)
WARNING
 Make sure that buttons Ⓐ are tightened.
 When equipped with the push bar, the push bar should always be mounted to increase the
stability of the back.
Risk of injuries
Risk of injuries
1. Pull the lever  on both sides towards the push handle 
to adjust the backrest.
2. The pen Ⓐ comes out of the groove of the toothed plate
Ⓑ.
3. Pull both back tubes backwards continuously to the
desired position (4 different positions: 5° - 15° - 25° - 35°).
4. Release the levers. Check that the pen Ⓐ is well fixed in
the groove of the toothed plate Ⓑ.
Risk of injuries
Eclips X2 Kids, Eclips X2 30° Kids
8
2022-06
Using your wheelchair
29
7