Kickback And Related Warnings - Skil 1415 Originalbetriebsanleitung

Do not run the power tool while carrying it at your
side.
Regularly clean the power tool's air vents. The
electrical hazards.
Do not operate the power tool near flammable
materials. Sparks could ignite these materials.
Do not use accessories that require liquid coolants.
electrocution or shock.

2) KICKBACK AND RELATED WARNINGS

binding.
material causing the wheel to climb out or kick out. The
under these conditions.
incorrect operating procedures or conditions and can be
Maintain a firm grip on the power tool and position
your body and arm to allow you to resist kickback
forces.
proper precautions are taken.
Use special care when working corners, sharp
edges etc. Avoid bouncing and snagging the
accessory.
Do not attach a thin toothed saw blade. Such blades
Always feed the bit into the material in the same
direction as the cutting edge is exiting from the
material (which is the same direction as the chips
are thrown).
When using steel saws, cut-off wheels, high-speed
cutters or tungsten carbide cutters, always have the
work securely clamped.
3) SAFETY WARNINGS SPECIFIC FOR GRINDING AND
ABRASIVE CUTTING-OFF OPERATIONS
Use only wheel types that are recommended for
your power tool and only for recommended
applications.
For threaded abrasive cones and plugs use only
undamaged wheel mandrels with an unrelieved
shoulder flange that are of correct size and length.
Do not "jam" the cut-off wheel or apply excessive
pressure. Do not attempt to make an excessive
depth of cut.
breakage.
Do not position your hand in line with and behind
the rotating wheel.
When the wheel is binding or when interrupting a
cut for any reason, switch off the power tool and
hold the power tool motionless until the wheel
comes to a complete stop. Never attempt to remove
the cut-off wheel from the cut while the wheel is in
motion, otherwise kickback may occur.
binding.
Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully re-enter the cut.
Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kickback.
Large workpieces tend to sag under their own weight.
Supports must be placed under the workpiece near the
Use extra caution when making a "pocket cut" into
existing walls or other blind areas. The protruding
objects that can cause kickback.
4) SAFETY WARNINGS SPECIFIC FOR WIRE
BRUSHING OPERATIONS
Be aware that wire bristles are thrown by the brush
even during ordinary operation. Do not overstress
the wires by applying excessive load to the brush.
or skin.
Allow brushes to run at operating speed for at least
one minute before using them. During this time no
one is to stand in front or in line with the brush.
Loose bristles or wires will be discharged during the
run-in time.
Direct the discharge of the spinning wire brush
away from you.
GENERAL
9