Change Oil Of The Pugmill - Rohde TS 20 Betriebsanleitung

5.2.

Change oil of the pugmill

The gearbox oil of the motor must be changed at the following intervals: The gearbox oil of the motor must be changed at the following intervals:
The gearbox oil of the motor must be changed at the following intervals: The gearbox oil of the motor must be changed at the following intervals:
Every 4000 operating hours or at the latest after 4 years.
Required oil: Required oil: Required oil: Required oil:
Approx. 0.5 litres of standard synthetic gearbox oil: SAE 85 W 90
ATTENTION ATTENTION ATTENTION ATTENTION:
For safety reasons, the pugmill must be disconnected from the power supply
before maintenance work.
Process of oil change: Process of oil change:
Process of oil change: Process of oil change:
Step 1: Step 1:
Step 1: Step 1:
Collect an oil sample.
Open the vent screw of the oil tank and use a rolled piece of paper to collect a sample of the oil.
Close the vent screw again!
Check if the oil is heavily contaminated. If this is the case,
the oil must be completely replaced!
22 / 28 - EN -