Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting
The mounting location should be protected from
the effects of weather.
5.2
Wall mounting
For the wall mounting with the supplied screws and plugs
please proceed as follows:
•
Choose a site for installation (see "5.1 General
notes on installation" on page 29).
Remove the cap (A) (see fig. 2).
•
Position the light sensor without cap (A) at the
•
desired location site and mark the bore holes (E)
with a pen (see fig. 3).
•
Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs sup-
plied. If you are working with a wooden wall, you
can pre-drill 1.5 mm holes to make screws easier
to insert.
•
Insert the plugs into the bore holes.
•
Position the light sensor and insert the screws
(see fig. 4).
•
Do not yet place the cap (A).
30
Werbung
Inhaltsverzeichnis
Fehlerbehebung
