Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuring the Network Packet Broker using the Console Port
Step 1: Connect a computer to the Network Packet Broker's console port using the console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameter of the HyperTerminal: 115200 bits per second, 8 data bits, no parity, 1 stop
bit and no flow control.
Quick Connect
Protocol:
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Step 4: After setting the parameters, click Connect to enter.
Troubleshooting
Loading Failure Processing
After loading fails, the system will keep running in the original version. At this time, users should
re-check if physical port connections are good firstly. If some ports are not connected, then
re-connect them to ensure that physical connections are correct and begin re-loading. If physical
connections are correct, then check the loading process information displayed on the super terminal
to verify if there are input errors. If there are input errors, correct them and re-load. For example,
when using TFTP protocol, we enter incorrect IP addresses of Server and Network Packet Broker,
name of loading software, do not specify the correct working path of correct TFTP server and so on; if
physical connections are good, and there are no input errors in the loading process, but the loading
fails finally, please contact agents for help.
10
Serial
Flow Control
COM3
DTR/DSR
9600
RTS/CTS
8
XON/XOFF
None
1
Save session
Open in a tab
Connect
Cancel
x
Werbung
Inhaltsverzeichnis
