Installing The Handlebar - Toro HoverPro 450 Bedienungsanleitung

2

Installing the Handlebar

Parts needed for this procedure:
4 T-bushings
2 Bolt (6 x 55 mm)
6 Washer (6 mm)
2 Locknut (6 mm)
2 Knob
2 U-bolt
Handlebar fitting
1 Upper handlebar
1 Bolt (1/4 x 1-3/4 inches)
1 Locknut (1/4 inch)
Assembling the Lower Handlebar
to the Machine
1. Assemble 2 T-bushings into the handlebar
flanges of the mower deck
1. T-bushings
2. Align the footstop of the handlebar to the up-stop
bracket on the deck
(Figure 5).
Figure 5
2. Handlebar flanges (mower
deck)
(Figure 6).
1. Up-stop bracket
3. Align the hole in the handlebar with the holes in
the bushings
to the machine with a bolt (6 x 55 mm), 2
washers (6 mm), and a locknut (6 mm).
g364682
1. Lower handlebar
2. Bolt (6 x 55 mm)
4. Repeat step
6
Figure 6
2. Footstop
(Figure 7), and secure handlebar,
Figure 7
3. Washer (6 mm)
4. Locknut (6 mm)
3 at the other side of the machine.
g364680
g364681