Connection; Network Connection - auna iTuner 320 BT Bedienungsanleitung

CONNECTION

1. The audio input/output (analogue), optical out (digital) and coaxial out
(digital) are available on the back of the unit to connect A/V amplifier or
HiFi system.
2. Connect the antenna included in the supply to the antenna connection
and extend it to the desired length.
3. Connect the WLAN antenna included in the supply to the W-LAN socket
at the back of the unit for WIFI connection.
4. Unwind the mains cable to its full length. Connect the mains plug to the
mains socket. The unit is now connected and ready to use.
Be sure to connect the power cord to an AC outlet that supplies the
correct voltage. Hold the power plug when plugging it into an outlet or
unplugging it. Never pull or yank on the power cord.
5. To switch the unit off completely, unplug the mains cable from the mains
socket.

Network Connection

This product only supports wireless network connection for network access
and does not support wired LAN connection.
Wireless network
1. Check first of all whether the control lamps (LINK/ACT) of your router
light up.
2. Proceed with the operations described in the below "Getting Started". It
is recommended to run through the setup wizard in the System Settings
section.
This unit cannot be connected to a standalone modem directly. A router or a
modem incorporated with a router has to be used.
Since there are various connection configurations, follow the specifications
and instructions of your telecommunication carrier, internet service
provider, and router setting guidebook.
EN
47