STAMOS Welding Group S-DIGITAC 200P Bedienungsanleitung Seite 27

Sheet Current(A)
thickness
(mm)
Pulse Basic value
0.3 20~22 5~8 0.06~0.08
0.5 55v60 10
0.8 85 10
5. CONNECTION
CONNECTION
!
DANGER
• The control panel shall be operated by the personnel who have qualific ations or
know the circuit of this welding machine.
• Before operation, the operator must disconnect the power switch of this welding
machine, the switch of the power distribution box supplying electricity to this
welding machine, the distribution switch of other electric appliances which have the
wiring relation (external terminal, etc) with this welding machine. The operation can
not be conducted until the capacitance of this welding machine is discharged for
5min.
In order to prevent the control panel from being damaged
!
Warning
due to static electricity when such control panel is touched.
Be sure to follow the instructions below.
• Never touch other unrelated parts.
• Before operation, be sure to make your hand fully contact the metal housing so as
to ensure the static electricity on you can be discharged to the ground.
EN
Duration (S) Pulse
frequency
Pulse Basic value (HZ)
0.06 8
0.08 0.06 7
0.12 0.08 5
Any live parts touched may cause electric
shock accidents. In order to prevent such
accidents, be sure to follow the
instructions below:
Rev. 02.03.2017
52
CONNECTION OF INPUT SIDE
Welding
Connection of earth wire
speed
(cm/min)
50~60 !
CAUTION
55~60
80~100
• Connect one end of the earth wire to the rear
grounding terminal
• Reliably ground the other end of the earth wire
Connect the air faucet with the air pipe reliably.
Connection of input power supply
!
DANGER
• Connect the cable on the input side to the
output terminal of the switch of the power
distribution box
CONNECTION OF OUTPUT SIDE
Connection of parent metal cable
• Please use the attached connector to
connect the parent metal cable to the
positive OUT socket
Connection of the cable on the side of the
electrode holder
• Please use the attached connector to
connect the electrode holder cable to
the negative OUT socket
Rev. 02.03.2017
EN
As the tap water pipe and reinforced bars for houses
have CAUTION no full grounding, never connect the
earth wire to such places.
Please configure one power distribution box for every
welding machine.
53