1
INSTALLATION
See the installation descriptions of each camera from page 3.
2
GENERAL INFORMATION
Dear Customer,
Thank you for purchasing this product.
This quick start guide was written to help you set up the following URMET IP cameras rapidly and easily: Ref.
1093/139M2 - Ref. 1093/141M2 - Ref. 1093/142M2 - Ref. 1093/176M2 - Ref. 1093/177M2 - Ref. 1093/178M2.
Read this quick start guide which contains information for correct, safe use carefully before using the device.
Keep this guide at hand so that you can refer to it when needed.
2.1
WARNINGS
Electricity
Before connecting to electrical outlet, verify the electrical specifications of the device are suitable for the
available power source.
We suggest to connect the device to electrical outlet via a switch disconnector.
In case of misfunctioning, disconnect electrical power from the general switch.
Use only the provided power supply.
Safety precautions
Do not expose the device to rain or humidity and do not insert any solid or liquid object in it to prevent the risk of
fire or electrocution. In these events disconnect the device from the electrical outlet and call technical
assistance to check it.
Do not open the device. Any repair must be made by qualified personnel or by calling the nearest authorized
technical assistance center.
Keep the device away from children to prevent any, even involuntary, damaging.
Do not touch the device with wet hands as it might cause electrical shock or mechanical damages.
If the device falls down while working or if the salesbox is damaged, do not continue using it. If usage is
continued under such circumstances electrical shocks might take place. Contact the authorized retailer or
installer.
Installation precautions
Do not install the camera in places with possible exposure to rain or humidity without the proper protective case.
Do not point the camera directly to sunlight or other intense sources of light, even when turned off. The subject
of recording must not be against the light.
Do not point the camera against reflective objects.
Some light conditions (such as fluorescent color) can affect the recorded colors.
Use AUTO-IRIS lens when operating the camera in changing light environments.
Do not use this device on any unstable support such as lurching or sloping table to prevent the device from
falling and be damaged.
If water or any other material should penetrate the camera, stop using it as it might cause fire or electrical shock
and contact the authorized retailer or installer.
Do not cover the device with any cloth while using to prevent deformation of the external part and inner
components heating which might provoke fire, electrical shock or mechanical damages.
Do not put magnets or magnetized objects close to the device to prevent functional anomalies.
Do not use this device in presence of smoke, steam, humidity, dust or intense vibrations.
Do not use the device shortly after moving it from warm to cold environment and vice versa. After moving the
device wait three hours before using it: this time is necessary for the device to adapt to the new environment
(temperature, humidity, etc.).
Usage precautions
Check the device is not damaged after removing the packaging.
Check the working environment is not too humid and the temperature is within the indicated range.
Do not point the camera against sunlight to prevent sensor damages.
Device cleaning
Use a dry cloth to remove dust and dirt from the device.
If dirt cannot be removed with a dry cloth, use a humid cloth and a neutral cleanser.
Do not use spray cleanser for device cleaning. Do not use volatile liquids such as gasoline, alcohol, solvents
etc. or chemical treated cloth to clean the device to prevent deformations, damages or scars on the finishing
paint.
Disconnect the device from the electrical outlet before cleaning.
Video recording
This device is not designed as a burglar system but mainly to transmit and record video images. URMET S.p.A.
is not in any way responsible for loss or damages of the user consequent to theft.
Before using the device, record a demo video to verify the correct functionality of this feature. URMET S.p.A. is
not in any way responsible for loss of recorded data consequent to wrong setting or usage, device
misfunctioning or failure.
DS1093-177
13