Item in
fig. 1,
Designation
page 3
13
Screw AW20-A2-3,9X32
–
Installation and Operating Manual for
the solar charger
Accessories
Available as accessories (not included in the scope
of delivery):
Description
Corner roof mounting support kit
MT EP
Connector bracket kit MT VP
MT iQ Solar Monitor LED I
MT iQ Solar Monitor LCD III
MT iQ SolarPRO
Roof duct with cable gland
(single)
Roof duct with cable gland
(double)
Intended use
The solar system is intended to convert sunlight
into direct current (DC) to charge rechargeable
12 V batteries in vehicles or boats while driving or
supply them with a float voltage for power genera-
tion. The battery power can additionally be used as
a stable power supply to operate DC-powered
devices connected to the battery.
The solar system is suitable for:
• Installation in caravans and motor homes
• Stationary or mobile use
• Extreme operating conditions (expedition use)
• Wind speeds up to 225 km/h
The solar system is not suitable for:
• Mains operation
Qty.
• Portable applications
The voltage output of connected solar panels may
16
not exceed the specified maximum output of the
1
solar charger.
This product is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the
product. Poor installation and/or improper operat-
SKU
ing or maintenance will result in unsatisfactory per-
formance and a possible failure.
9620000201
(EP 00030)
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
9620000308
• Incorrect assembly or connection, including
(VP 00027)
9620000230
• Incorrect maintenance or use of spare parts
(MT 71242)
9620000328
(MT 01250)
• Alterations to the product without express per-
9620000309
(MT 01240)
• Use for purposes other than those described in
9620000207
(DD 00100)
Dometic reserves the right to change product
appearance and product specifications.
9620000267
(DD 00200)
Technical description
The solar panels are equipped with 72 half-cut
monocrystalline solar cells, which are connected in
parallel as cell strips so that power can be gener-
ated even in unfavorable weather conditions and
partial shading.
The side roof mounting supports are glued to the
vehicle roof without drilling. The solar panels are
screwed onto the side roof mounting supports and
are replaceable.The wiring to the interior is routed
through a pressurized water-tight roof duct.
The solar system can be extended by further solar
panels of the same power.
MT 150-2 MC Slim, MT 160-2 MC, MT 220-
2 MC,MT 260-2 MC, MT 340-2 MC: Both solar
panels can be connected to each other at one junc-
tion box.
4445103705
excess voltage
other than original spare parts provided by the
manufacturer
mission from the manufacturer
this manual
11