Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Push the rubber gas hose (D) onto the hose connection (A) and fasten it with a
clamp (E): s. fig. below. The clamp must comply with the applicable standard.
4. Ensure that the rubber gas hose is installed properly.
5. Carry out a leak test (e.g. with soap solution, never with a flame).
A
B
C
D
E
WARNING! Never forget to insert the seal!
WARNING! The tightening torque between connections containing a
seal must not exceed 10 Nm.
WARNING! After installation, a leak test of the gas hose, gas hob and
the complete installation must be carried out. Ensure, that the main
connection does not exert any tension on the hob. The gas hose must not
contact any movable part and must not pass any place in which it can be
kinked or blocked.
H
OSE CONNECTION
G
AS CONNECTION OF THE APPLIANCE
S
EAL
R
UBBER GAS HOSE
C
(according to standard)
LAMP
~
~
135
Werbung
Inhaltsverzeichnis
