Assembling The Glass Elements; Installing Roof Trim; Mounting The Cover Slats; Drill Hole For Electrical Cable - Harvia VARIANT VIEW Mini Bedienungsanleitung

Instructions for installation

3.5. Assembling the glass elements

Fit the aluminium U-profiles on the glass elements and install the glass elements
in the cabin.
Note when installing the glass element that the holes drilled for the door
hinges determine which way the door opens.
Bond the aluminium U-profiles to the floor with silicone or assembly
adhesive.
Mount the spacer strip above the glass door.
When installing the door fittings, make sure that the door opens to the outside.
Screw the two door fittings to the glass element first, making sure that the fittings
are aligned straight. Align the fittings by adjusting / turning the two plastic inserts.
The door handles are screwed together from the inside. Attach plastic washers
on the stainless steel handle
Fit the door magnet and sleeve plate.

3.6. Installing roof trim

Mount the corner brackets to the roof trim strips. Then screw the roof trim strips
to the roof element.

3.7. Mounting the cover slats

Fasten the inner roof corner trims, the inner corner trims and the outer corner
covers using nails.

3.8. Drill hole for electrical cable

3.9. Mounting the light

3.10. Installation KIT for heater installation at the bench foot

Only required if the sauna heater is mounted on the bench foot in order to main-
tain the safety distances.
p. 13/14
EN