Antennenbaugruppe; Removing The Antenna (Location 1) - Dell OptiPlex 3000 Thin Client Servicehandbuch

About this task
The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1. Align the screws on the heat sink with the screw holders on the system board and place the heat sink on the processor.
2. Tighten the four captive screws to secure the heat sink to the system board.
NOTE: Tighten the four captive screws in ascending order (1,2,3,4) as printed on the heat sink.
Next steps
1. Install the side cover.
2. Follow the procedure in

Antennenbaugruppe

Removing the antenna (Location 1)

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the WLAN card.
About this task
The following image indicates the location of an internal antenna and provides a visual representation of the removal procedure.
32 Entfernen und Einbauen von Komponenten
after working inside your
before working inside your
computer.
computer.