Bright 018208 Bedienungsanleitung Seite 50

EN
USE
QUICK START GUIDE
More detailed instructions can be found in the respective section in the operating instructions.
1 Start the appliance.
2 Fill the detergent compartment.
3 Check the rinse-aid level.
4 Check the salt level.
5 Load the basket
6 Select programme
7 Start the dishwasher
(8) Changing programmes
Loading while dishwashing
(9)
is in progress.
If the appliance is switched
(10) off while dishwashing is in
progress.
11 Switch off the appliance.
Close the water tap and take
12
out the dishes.
50
Press the power switch to start the appliance. Open the panel.
Compartment A: For each wash cycle.
Compartment B: Only for programme with prewash.
(Follow the instructions.)
Mechanical indicator C.
Electrical indicator on the control panel
(if available).
Only on models with system for water softener.
Electrical indicator on the control panel
(if available).
On models that do not have a status lamp on
the control panel the number of wash cycles
indicates when it is time to fill salt.
Scrape off large scraps of food and soak burned scraps before the dishes are put in
the basket. See instructions for the loading the dishwasher.
Close the panel. Press the programme button until the status lamp for the required
program goes on. See section on use.
Open the water tap and press the start/stop button.
The appliance starts after approx. 10 seconds.
1. It is possible to interrupt the programme in use and switch to any another programme
at any time during the wash cycle, but if the detergent compartment has been opened
new detergent must be filled before the new programme is started.
2. Press the start/stop button and then hold the programme button pressed for at least
3 seconds to interrupt the programme in use.
3. Select another programme.
4. Start the dishwasher again.
1. Press the start/stop button to stop
the appliance.
2. Open the panel.
3. Load extra dishes.
4. Open the panel and press the start/stop
button. The appliance starts after approx.
10 seconds.
If the appliance is switched off while dishwashing is in progress, start it by following
the above instructions.
When the wash cycle is complete the buzzer sounds 8 times.
Switch off the appliance with the power switch.
The appliance switches off automatically after 30 seconds if there is no activity.
WARNING!
Allow the dishes to cool for about 15 minutes before unloading – dishes are sensitive to
knocks when hot.
The dishes also dry better if they are allowed to cool in the dishwasher. Unload the bottom
basket first.
WARNING!
Open the panel carefully – risk of
scalding from steam or hot water.