Herunterladen Inhalt Inhalt Diese Seite drucken

Weh TW241 Betriebsanleitung Seite 30

Adapter zur druck- und vakuumprufung von glattrohren
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

AE
Operating instructions
Î
Put the washer, the new
front seal (Pos. 7) and the
second washer back into the
housing.
Attention: Observe the
installation direction of the
washers. The large chamfer
must point away from the
front seal.
Î
Put the pressure spring back
into the housing.
Î
Apply the
WEH
Lubricant
®
part No. 74725 all around the
thread of the lower part with
a brush.
Î
Clamp the housing in a vice
with the appropriate
WEH
Clamping jaws.
®
Î
Screw the base unit together.
Î
Tighten the housing using a
torque wrench and the rolling
fork insertion tool.
Tightening torque
20 Nm ± 2 Nm
Page 30
MD-10026-L51-R1.0.0-03
Washers with the large cham-
fer facing outwards

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis