Getting Started; Setting The Time - Bigben Interactive Wood Bedienungsanleitung

REMOTE CONTROL
Remove the plastic insulator tag sticking out of the battery compartment of the remote control by pulling
on it. Once the tag is removed, the remote control will be ready for use.
1. STANDBY button
2. MUTE button
3. FUNCTION button
4. PLAY/PAUSE button
5. TUNE-/BACK button
6. STOP button
7. MODE button
8. BAND button
9. CD door OPEN/CLOSE button
10. RECORD button
11. DELETE button
12. TUNE+/NEXT button
13. FOLDER+/MEM+ button
14. PROGRAMME/CLOCK SET button
15. FOLDER-/MEM- button
16. BASS button
BATTERY REPLACEMENT
When the battery runs low, the distance at which the remote control will operate is
greatly reduced and you will need to replace the lithium battery.
1. Remove the battery compartment from the bottom of the remote control.
2. Install 1 CR2025 lithium battery with the positive side facing up.
3. Replace the battery compartment.
USING THE REMOTE CONTROL
1. To use the remote control, point it at the remote sensor and press the button gently but firmly. Since
the remote control range is reduced when the unit is used at an angle, try to aim it directly at the
remote sensor.
2. Do not expose the remote sensor to strong light (direct sunshine or artificial light) and make sure that
there are no obstacles between the remote sensor and the remote control.
CONNECTING THE AC POWER CORD
1. Unwind the AC power cord and connect it to a household 230V~ 50Hz AC outlet.
1. In Standby mode, press and hold the Programme/Clock set button (19) for 3 seconds. "24 Hr" will be
displayed blinking.
2. Press the BACK/NEXT buttons (15, 17) to select the clock display format (12 hrs or 24 hrs).
Press the Programme/Clock set button (19) to confirm; the hour digits will blink. Press the
BACK/NEXT buttons (15/17) to set the hour. Press the Program/Clock set button (19) to confirm; the

GETTING STARTED

SETTING THE TIME

4