EINHELL TE-BJ 18 Li Originalbetriebsanleitung Seite 19

Danger: Never press the spindle lock (9) while
the motor is running. Check that the cutter is stati-
onary and securely seated before starting work.
Note: Do not use blunt or damaged disk cutters.
5.7 Charging the battery (Fig. 10-11)
1. Remove the battery pack (a) from the handle,
pressing the pushlock button (b) downward to
do so.
2. Check that your mains voltage supply mat-
ches the voltage shown on the rating plate
of the battery charger. Insert the power plug
of the charger (c) into the power socket. The
green LED starts to fl ash.
3. Insert the battery pack into the charger.
4. In the section entitled „Charger indicator" you
will fi nd a table with an explanation of the LED
indicator on the charger.
The battery pack can become slightly warm du-
ring charging. This is normal.
If the battery pack does not charge, check:
•
whether mains voltage is present at the pow-
er socket
•
whether there is good contact at the charging
contacts
If the battery pack still does not charge, please
send
•
the charger
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Anl_TE_BJ_18_Li_SPK13.indb 19
GB
5.8 Battery capacity indicator (Fig. 12)
Press the button for the battery capacity indicator
(d). The battery capacity indicator (e) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
6.1 On/Off switch (Fig. 3; item 1)
To start the unit, slide the On/Off switch (1) for-
ward and press it down. To switch off the biscuit
jointer, depress the On/Off switch (1) at the back.
The On/Off switch (1) will jump back into its star-
ting position.
6.2 Marking a workpiece (Fig. 13)
Before you start working with the biscuit jointer,
the workpiece must be marked as follows:
•
Place the two parts side by side; the workpie-
ces must be securely clamped.
•
Draw a line with a pencil at right angles to the
joint.
•
Multiple joints will be required on longer pie-
ces of wood.
•
The distance between two lines should be at
least 10 cm.
Note:
On thicker workpieces you can create additional
stability by cutting two slots one above the other;
on thinner workpieces a single joint will be suf-
fi cient.
- 19 -
10.11.2021 08:20:28