Celestron STARSENSE EXPLORER 8 DOBSONIAN Kurzanleitung Zur Einrichtung Seite 4

5
5. Connect the assembly to the bottom plate (D). Place one of the
steel washers (H3) and the plastic cylinder (H4) onto the bolt
(H1). Then, insert the bolt through the central hole in the bottom
plate. Next, place the Tefl on washer (H5) over the plastic
cylinder (H4) now protruding from the bottom plate. Take the
assembled base and lower it onto the bottom plate so that the
plastic cylinder goes through the central hole in the top plate.
Now, place the remaining steel washer (H3) on the end of the
bolt protruding from the top plate. Thread the nut (H2) onto
the bolt.
7
J2
7. Install the base handle (J1) onto the front panel (B) using the
2 handle screws (J2).
4 I ENGLISH
H2
H3
H5
D
H4
H3
H1
J1
B
6
6. Use the two crescent wrenches to tighten the nut onto the bolt.
Hold the head of the bolt stationary with one crescent wrench
while using the other crescent wrench to tighten the nut.
DO NOT OVERTIGHTEN THE NUT! With some force, you
should still be able to move the steel washer underneath the
nut with your fi ngers. If the washer cannot be moved with your
fi ngers, slightly loosen the nut.
8
8.
Install the eyepiece rack (K1) onto the front panel (B) using the
2 rack screws (K2). Note: If you want to remove the rack after it
has been installed, simply pull it upwards.
K1
K21