VOLTCRAFT VC-890 Bedienungsanleitung Seite 70

8. The "OFF" setting turns the display off if the device is not operated for 5 minutes. Only the symbol
and the memory number are displayed. If the device is continually saving measured
values ("OVERWRITE" setting) and "1000" measured values are exceeded, a blinking infinity
symbol "∞" is displayed below
9. By default, the device is set to "OFF".
10. Hold down the SHIFT/SETUP button for approx. 2 sec to save the setting and exit the SETUP
menu. You will also exit SHIFT mode.
When the display is switched off in energy saving mode, turn the rotary switch or press any
button (apart from the
Viewing saved measured values:
1. With the measuring device switched on, hold down the SHIFT/SETUP button (3) for approx. 2 s.
will appear on the display. You are now in SHIFT mode.
2. Now press the MAX/MIN (View/►) button (10b) to switch to the display mode.
on the display with the first memory number "0001" below it. The saved measured value is shown
in the centre of the display.
3. Press the H/LIGHT (+/COMP) or RANGE (-) buttons to show the individual records.
4. Press the MAX/MIN (View/►) button again to exit the display mode.
5. Press the SHIFT/SETUP button to exit the SHIFT mode.
The stored measured values of a comparison measurement are shown in the display with the
symbols
If "VOID" appears in the display, that means that the measured value memory is empty.
Deleting saved measured values:
1. With the measuring device switched on, hold down the SHIFT/SETUP button (3) for approx. 2 s.
will appear on the display. You are now in SHIFT mode.
2. Hold down the MAX/MIN (View/►) button (10b) for approx. 2 s. The indication
will briefly appear on the display. All measured values are deleted.
3. Press the SHIFT/SETUP button to exit the SHIFT mode.
72
.
-button (9)) to turn it back on.
and .
will appear
and "VOID"