Replacing The Power Cable; Ordering Replacement Parts - EINHELL TE-VC 18 Li Originalbetriebsanleitung

If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.4 Battery capacity indicator (Fig. 6/Item d)
Press the button for the battery capacity indicator
(e). The battery capacity indicator (d) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
Anl_TE_VC_18_Li_SPK13.indb 15 Anl_TE_VC_18_Li_SPK13.indb 15
GB
6. Operation
On/Off switch (Fig. 1/Item 1)
Switch position OFF: Off
Switch position ON: On

7. Replacing the power cable

Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
We recommend cleaning the equipment im-
mediately each time after use.
7.2 Cleaning the tank (3)
The tank can be cleaned with a damp cloth and
some soft soap or under running water, depen-
ding on the amount of dirt.
7.3 Cleaning the fi lter (9)
Clean the fi lter (9) under running water and allow
it to air-dry.
7.4 Maintenance
At regular intervals and before each use, check
that the fi lters in the vacuum cleaner are securely
fi tted. If you are not going to use the equipment
for an extended period of time, remove the bat-
tery.

7.5 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 15 -
04.05.2022 09:58:09 04.05.2022 09:58:09