Waeco AirCon Service 6300G Bedienungsanleitung Seite 24

English
R1234yf from system
g.
PRINT STOP-EXIT
Here a total of 2400 g of refrigerant was extracted in January 2017.
In the monthly overview the filled and extracted amount is always displayed alternately.
Press ENTER to print out the overview. Press STOP to exit the overview.
13.7 Testing the air conditioning system without refrigerant service
Note The air conditioning system can only be tested on vehicles with a low pressure port and a high
pressure port or with a low pressure port only.
If you only test the function of a vehicle air conditioning system without drawing off and recycling the refrigerant,
the vehicle air conditioning system would lack the refrigerant remaining in the service hoses of the air conditioner
after the test. The A/C system test menu item has been added to compensate for this loss.
The existing standard function processes Short selection and Free selection already have a compensation
function for service hoses, which means the final air conditioning function test can be carried out in the usual man-
ner (the service hoses are drained by the A/C service unit).
1. First, fit the connections of the A/C service unit to the vehicle air conditioning system and open them.
2. Start the vehicle's engine and switch on the air conditioning system.
3.
In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
Press ENTER to confirm.
4.
5.
Use the cursor keys
A/C system test
Service.
ENTER-OK STOP-EXIT
A prompt appears asking you to check the air conditioning system:
Check the A/C system
STOP-EXIT
6. Check the high and low pressure of the air conditioning system in accordance with the manufacturer's spec-
ifications.
To end the air conditioning system test, press STOP.
7.
Disconnect the HP
service hose from
the A/C system
ENTER-OK
22
01/2017
2400
or to select Other selections.
or to select A/C system test.