Overload Protection; Overheat Protection - Makita DLM330 Betriebsanleitung

Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend machine and battery life.
The machine will automatically stop during operation if
the machine or battery is placed under one of the fol-
lowing conditions.

Overload protection

When the machine/battery is operated in a manner
that causes it to draw an abnormally high current, the
machine automatically stops and the indicator lamp
lights up in red. In this situation, turn the machine off
and stop the application that caused the machine to
become overloaded. Then turn the machine on to
restart.

Overheat protection

When the machine is overheated, the machine stops
automatically and the indicator lamp lights up in red.
Let the machine cool down before turning the machine
on again.
Overdischarge protection
When the battery capacity becomes low, the machine
stops automatically and the indicator lamp lights up in
red. If the machine does not operate even when the
switches are operated, remove the battery from the
machine and charge the battery.
Protections against other causes
Protection system is also designed for other causes that
could damage the machine and allows the machine to
stop automatically. Take all the following steps to clear
the causes, when the machine has been brought to a
temporary halt or stop in operation.
1. Turn the machine off, and then turn it on again to
restart.
2. Charge the battery(ies) or replace it/them with
recharged battery(ies).
3. Let the machine and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.
NOTE: The timing, at which the lamp lights up,
depends on the temperature at work place and the
battery cartridge conditions.
Indicating the remaining battery
capacity
► Fig.14: 1. Indicator lamp
When the remaining battery capacity gets low, the
indicator lamp blinks in red. By further use, the machine
stops and the indicator lamp lights up in red. In this
situation, charge the battery cartridge.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► Fig.15: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Switch action
WARNING:
always check to see that the switch lever actuates prop-
erly and returns to the original position when released.
Operating a machine with a switch that does not actuate prop-
erly can lead to loss of control and serious personal injury.
NOTE: The mower does not start without pressing the
switch button even the switch lever is pulled.
NOTE: Mower may not start due to the overload
when you try to mow long or dense grass at a time.
Increase the mowing height in this case.
This mower is equipped with the lock key and handle
switch. If you notice anything unusual with either of these
switches, stop operation immediately and have them
checked by your nearest Makita Authorized Service Center.
1. Install the battery cartridge. Insert the lock key,
and then close the battery cover firmly.
► Fig.16: 1. Battery cartridge 2. Lock key
2.
Press the switch button and hold it.
3.
Hold the upper handle and pull the switch lever.
► Fig.17: 1. Switch button 2. Switch lever
4. Release the switch button as soon as the motor starts running.
The mower will continue to run until you release the switch lever.
5. Release the switch lever to stop the motor.
15 ENGLISH
Off Blinking
Before installing the battery cartridge,
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.