2. Important Safety Instructions
The following guidelines shall help minimize the risk of injury through fire or electric shock.
C AU T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AT T E N T I O N
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
1.
Carefully read these safety notes before you use the
device!
2.
Keep these safety notes in a safe place.
3.
Pay attention to all warnings, instructions and additi-
onal texts on the unit.
4.
This device was only designed for operation under
normal climatic conditions (temperate climate).
5.
Do not install or use your amp in close proximity to
water or if you are wet yourself.
6.
Do not subject your device to sudden and severe
temperature changes. This could cause moisture con-
densation inside the unit, which could damage it. In
the event of moisture condensation allow the device
to dry out completely before use.
7.
Use your amp in a safe place where nobody can step
on cables or trip over and damage them.
8.
Pay attention to an unhindered air circulation around
the amp, never obstruct the air vents or grilles.
9.
Always pull the mains plug before cleaning your amp
or when left unused for a long period of time. Use
only a dry cloth for cleaning. Avoid the use of deter-
gents and do not let any liquids seep into the unit.
10. Use only the right fuses with the same current rating
and trigger characteristic as replacements. Never
mend fuses! Pull the mains plug before replacing a
fuse. Should a fuse blow again after a short while, the
device needs to be checked.
11. Never install your amp close to devices with strong
electromagnetic fields such as large mains transfor-
mers, revolving machines, neon illumination etc. Do
not lay signal cables parallel to power current cables.
12. There are no user-serviceable components inside the
unit. To avoid the risk of an electric shock, the unit
must not be opened. All maintenance, adjustment
and repair works should be carried out by qualified
staff only. Any unauthorized tampering will void the
2-year warranty.
The lightning flash
with the arrow head
symbol within an equilateral
triangle is intended to alert the
user to the presence of unisolated
´dangerous voltage´ within this
product´s enclosure that may
be of sufficient magnitude to
constitute a risk of electric shock
to persons.
13. In keeping with the EMV regulations screened cables
14. Always use an earthed power supply with the correct
15. Cable up your amp only when it is powered off.
16. This device should be installed near the socket outlet
17. This product may cause permanent hearing loss. Do
18. The product should be located away from heat sour-
19. Do not place any open sources of fire, like candles, on
20. Care should be taken so that objects do not fall onto
21. Do not place this device on an unstable cart, stand,
triangle is intended to alert the
user to the presence of important
operating and maintenance (ser-
vicing) instructions in the literatu-
re accompanying this product.
with correctly fitted connectors must be used for all
signal connections.
mains voltage. If you are in doubt about the power
outlet ground, have it checked by a qualified technici-
an.
and disconnection of the device should be easily
accessible. The mains plug of the power
supply shall remain readily operable. Protect the
power cord from being walked on or pinched particu-
larly at plugs, convenience receptacles and the point
where they exit from the apparatus.
not operate for long periods of time at a high volume
level or at any level that is uncomfortable. If you
experience any hearing loss or ringing in the ears,
you should consult an audiologist.
ces such as radiators, heat registers or other products
that produce heat.
the device.
the device and liquids are not spilled into the enclo-
sure through openings. Ensure that no objects filled
with liquids, such as vases, are placed on the device.
tripod, bracket or table. The device may fall, causing
serious injury to you and serious damage to the
device itself.
The exclamation point
within an equilateral
11