Remote Control; Placement And Mounting; First Time Installation; Wall Mounting - Sharp HT-SBW110 Schnellstartanleitung

EN
4

Remote control

1. – Switch the unit between ON and STANDBY mode.
2. – Select the Bluetooth mode.
Press and hold to activate the pairing function in Bluetooth mode or
disconnect the existing paired Bluetooth device.
3. – Select the play function.
4. VOL +/- – Increase/decrease the volume level.
5. / – Skip to previous/next track in Bluetooth mode.
6. – Play/pause/resume playback in Bluetooth mode.
7. – (MUTE) Mute or resume the sound.
8. BASS +/- – Adjust bass level.
9. TRE +/- – Adjust treble level.
10. EQ – Select a preset sound mode.

First time installation

Prepare the Remote Control
The provided Remote Control allows the unit to
be operated from a distance.
• Even if the Remote Control is operated within the eff ective range of 6m,
remote control operation may be impossible if there are any obstacles
between the unit and the remote control.
• If the Remote Control is operated near other products which generate
infrared rays, or if other remote control devices using infra-red rays are
used near the unit, it may operate incorrectly. Conversely, the other
products may operate incorrectly.
Replace the Remote Control Battery
1. Press and slide the back cover to open the battery compartment of the
remote control.
2. Insert two AAA size batteries (included). Make sure the (+) and (–) ends
of the batteries match the (+) and (–) ends indicated in the battery
compartment.
3. Close the battery compartment cover.

Placement and Mounting

A
A: Normal Placement (place Soundbar on leveled surface in front of TV)
B: Wall Mounting

Wall Mounting

NOTE:
– Installation must be carried out by qualifi ed personnel only. Incorrect
assembly can result in severe personal injury and property damage (if
you intend to install this product yourself, you must check for installa-
tions such as electrical wiring and plumbing that may be buried inside
the wall). It is the installer's responsibility to verify that the wall will safely
support the total load of the unit and wall brackets.
– Additional tools (not included) are required for the installation.
– Do not overtighten screws.
– Keep this instruction manual for future reference.
– Use an electronic stud fi nder to check the wall type before drilling and
mounting.
1
3
B
764mm
2
764mm