Husqvarna K1 PACE Bedienungsanweisung Seite 24

To set the pipe cutting mode
WARNING:
blade guard can be very hot, use gloves
when you adjust the blade guard.
WARNING:
during pipe cutting operation. In all other
operations you must use standard cutting
mode
The pipe cutting mode enables pipe cutting in the
kickback zone.
1. Move the stop bolt of the blade guard from the
standard cutting mode (A) to the pipe cutting mode
(B).
A
24
The adjustment handle for
Only use pipe cutting mode
B
2. Pull the adjustment handle to enable the pipe cutting
mode.
3. Put back the stop bolt to the standard cutting mode
after the pipe cutting operation. The arrow (A) shows
the standard cutting mode.
Wet cutting
CAUTION:
together with the wet system.
• Diamond blades for wet cutting must be used with
the wet system.
• Water cool the blade and increases its service life
while also decrease the dust.
A
Do not use Vac equipment
1598 - 002 - 14.02.2022