Teka RVU 20046 GBK Gebrauchsanweisung Seite 31

OPERATING YOUR WINE COOLER/BEVERAGE COOLER
 Control System Instruction

① " " Button
To control this appliance turn on/off
3 seconds).

② " " Button
To control the inner light turn on/off.

③ " " Button
To set the temperature of the upper chamber

④ " " Button
To set the temperature of the lower chamber.

⑤ LED display window
To set the temperature of the upper chamber.

⑥ LED display window
To set the temperature of the lower chamber.

⑦ indicator light
Compressor in operation display.
 Setting The Temperature Controls

When pressing "
lower compartment automatically. The LED will flashing and display the setting temperature.
Press once the button, the temperature will decrease or increase 1 ℃. When exceeding the minimum
value that can be established, it will jump to the highest adjustable temperature value automatically.
After stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to display
the temperature of the upper or lower compartment.

If you want to reveal actual temperature, please press and hold the " UP " or " DOWN " button for 3
seconds, the LED will flash and display the actual temperature. After stopping pressing the button for 5
seconds, LED figure will stop flash, then revert back to display the set temperature.
Upper compartment: The temperature setting can be adjusted from 5℃ to 10℃.
Lower compartment: The temperature setting can be adjusted from 10℃ to 18℃.
 Temperature Alarm
If the temperature inside is higher than 23
alarm / buzzer will sound. This indicates that the temperature inside is too high. If the temperature inside is lower than
℃
0 , it will display "LO" on the display panel and at the same time the alarm also malfunction indicator is active.
AND SETTING THE TEMPERATURE CONTROL
" or " " button, the system will be entering the set up mode in the upper or
℃
, it will display "HI" on the display panel, and after one hour after the
( press and hold this buttons for approximately
.
29