Headrest Adjustment; Installation Of The Safety Seat In A Car Using A 3-Point Seat Belt; Installation Of The Safety Seat In A Car Using A 3-Point Car Seat Belt - Lionelo Nico Bedienungsanleitung

•
Loosen the straps (see section 4.3) and turn the seat so as to get access
to the rear part.
•
Pull the both straps out of the strap connector (fig. 19).
•
Then pull the seat belts from the front of the seat until they come out of
the seats at the back of the seat and from underneath (fig. 20).
•
Now, you can remove the straps and the buckle by pulling them upwards (fig. 21).
•
If you want to install the 5-point safety harness, please follow the above
steps in reverse order.
•
All the removed parts of the safety harness should be stored for future purposes.

5.2 Headrest adjustment

Please check regularly whether the height of the headrest is suitable for your child.
It is true when the baby's head rests comfortably in the middle of the headrest.
In order to adjust the height of the headrest please complete the following steps (fig. 22):
•
Turn the seat so as to get access to the rear part.
•
Push and hold the headrest adjustment button. Now you can pull the headrest
out or push it inside.
•
Release the headrest adjustment button. Now, the headrest is properly locked.
Each time you adjust the height of the headrest make sure it has been properly
secured (locked).

5.3 Installation of the safety seat in a car using a 3-point seat belt

Step 1: Place the safety seat on the car seat in a way so that it rests tightly against
the vehicle backseat (fig. 23).
Step 2: Place your child in the safety seat (fig. 24).
Step 3: Fasten the 3-point car seat belt in a way so that the clasp is in the car
buckle on the other side of the safety seat.
Run the lap belt so that it passes under both armrests. Make sure it is not twisted
and runs low enough, in order to support the pelvis.
When inserting the clasp in the buckle you will hear a „click" sound.
Step 4: Run the shoulder belt through the guide on the side of the headrest.
Ensure that it is not twisted. Tighten the shoulder belt (in the direction of the
auto-roll) (fig. 25).
In case of any questions concerning the installation method, please contact the seat
manufacturer.

5.4 Installation of the safety seat in a car using a 3-point car seat belt

Installation of the seat base alone is only suitable for Group III (22 - 36kg).
‑ 13 ‑ EN