Charging The Battery; Accessories - Chicco N0002 Gebrauchsanleitung

stimulation mode: in this case it is recommended to re-
charge the battery and, if necessary, to use the product
in battery charging mode. Otherwise, the appliance will
switch off automatically after a few minutes.

CHARGING THE BATTERY

To charge, connect the motor body (13) to a PC using the
USB cable. To reduce charging time, it is recommended to
charge with the appliance switched off.
During charging with the USB cable inserted and the prod-
uct switched off, the battery charging status will be indi-
cated by the LED indicator (14) lit with a steady white light,
the fully charged status by the LED indicator (14) lit with a
steady blue light.
When using the appliance while charging the battery, it is
not possible to indicate the appliance's charge status.
• WARNING: immediately after each single use, carefully
clean all the components* as shown in the "CLEANING"
paragraph.
• To feed the milk immediately to your baby, unscrew the
feeding bottle from the pump body (4) to remove it.
Screw the ring with the teat (7) (included in the pack)
onto the feeding bottle. This way, you will obtain a handy,
ready-to-use baby feeding bottle.
• If, on the contrary, you close the bottle with the airtight
cap (8) (included in the package) you can store the ex-
pressed milk in the fridge for up to 48 hours at 4°C or for
up to 3 months at -18°C in the freezer.
• WARNING: When the breast pump is not used, always dis-
connect the USB cable from the motor body and PC.
*Excluding the motor body (13), USB cable (9,10) and sili-
cone tube (19).
CLEANING
• Before carrying out any cleaning operation, disconnect, if
connected, the USB cable from the PC and the USB cable
plug (9) from the USB cable input (12) on the motor body.
• Separate all the components from the breast pump.
Note: remove the valve (5), located on the circular duct in-
side the base of the pump body (4) by gently pulling the
tab on the side of the valve.
• WARNING: Make sure that the valve is always removed in
a gentle way; do not use any tool for cleaning it because
it may be damaged, making the breast pump impossible
to use.
Note: to remove the silicone tube, first detach the mem-
brane (1) and the membrane cover from the pump body,
to avoid any spillage. Then, holding the end inserted into
the membrane cover, gently pull it off.
• Carefully wash all the components* using hot water and
washing up liquid, thoroughly rinse and dry carefully us-
ing a soft and clean cloth.
• Do not use abrasive products to clean the breast pump
and its components.
• Clean the motor body with a soft, clean and dry cloth.
Warning! Do not wet the appliance or put it into water
or other liquids.
• The tube may be rinsed and suitably dried.
• All the components, with the exception of the motor body
(13), the USB cable, the valve (5), the membrane (1), the
silicone cover (3) and the tube (19) may also be washed
in a dishwasher using a delicate programme. This washing
method, which is more aggressive than hand washing,
may discolour or dull and degrade the material over time.
• Also clean and sanitise the feeding bottle (6) and its acces-
sories (7)-(8), according to the instructions included with
the bottle.
• After washing, always store the product in a clean, dry
place.
*Excluding the motor body (13), USB cable (9,10) and sili-
cone tube (19).

ACCESSORIES:

- NaturalFeeling feeding bottle 150 ml
/ 00080811000xxx.
- NaturalFeeling milk container
- Where XXX=variable identification code identifying the
country of sale.
• No accessories other than those recommended must be used.
19
00080711000xxx
00002257200000