Cameo OTOS H5 Bedienungsanleitung Seite 30

If the hotspot is not in the centre of the projection of the light beam, it can be calibrated by means
of two adjustment screws.
Example:
1. Fully disconnect the spotlight from the mains (pull out the mains plug)! Make sure that the
spotlight has cooled down completely!
2. Lock the spotlight head to prevent unintentional twisting (pan and tilt locking).
3. Loosen the 4 Allen screws of the rear head cover (see markings), remove the cover from the
spotlight head, release the safety cable of the cover and place it to one side.
4. Loosen the 4 silver-coloured Allen screws that hold the fan unit to the spotlight head (see
markings) and hang them carefully on the safety cable. Ensure that the supply lines are not
damaged.
3
30
4