Switching On The Transmitter - Reely Jet Gyro Bedienungsanleitung

b) Switching on the transmitter
Check the correct power supply of the transmitter by put-
ting it into brief operation for test purposes.
Caution, important!
Before switching on the transmitter, make sure
that the joystick for the drive motors (1) is in the
rear position (lower position in the figure).
When you press the on/off switch (4), the transmitter LED
(2) starts to flash.
Now push the joystick for the drive motors all the way for-
ward (up) and back to the rear (lower) position. The trans-
mitter LED will now glow steadily.
To switch off the transmitter again, press the on/off switch
again.
When the power supply is not enough to ensure proper operation of the transmitter, the transmitter LED starts to flash.
In this case, discontinue using the model aircraft and replace the old batteries in the transmitter with new fresh ones.
Figure 8
43