Cleaning The Device - urmet 1096/310 Bedienungsanleitung

This menu is used to vary the image viewing mode. Select this item to access the following submenu:
CONTRAST
SHARPNESS
COLOR GAIN
DNR
TRANSFER MODE
FORMAT
DWDR
RETURN
CONTRAST
Point to this parameter to edit the contrast value. Levels which can be set from 1 to 50
SHARPNESS
This is used to vary image definition by setting values from 1 to 20.
COLOR GAIN
Allows you to vary the color saturation of the images, by setting values from 1 to 16.
DNR (NOISE REDUCTION)
This function (Dynamic Noise Reduction) is used to reduce 3D digital image noise visible particularly in
absence of light. Levels which can be set from 1 to 15
TRANSFER MODE
The camera can use four different video outputs, on the same BNC connector:
•
High definition video output AHD (Analog High Definition)
•
CVBS standard interlaced video output
•
Video output in TVI or CVI mode. The correct working of these standards depends upon the
compatibility of the conncted devices, that can be guaranteed only for the devices of Urmet
catalogue.
FORMAT
Selection of PAL or NTSC
DWDR
The function D-WDR is the digital version of WDR (Wide Dynamic Range). This allows a better balance of
brightness of light and dark areas to obtain a more detailed image .
Select ON to activate the function

CLEANING THE DEVICE

•
Rub delicately with a dry cloth to remove dust and dirt.
•
Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
•
Do not use volatile liquids (such as petrol, alcohol, solvents, etc.) or chemically treated clothes to
clean the device to prevent deformation, deterioration or scratches to the paint finish.
20
VIDEO SETTING
IMAGE ENHANCE
13
8
10
6
AHD
PAL
OFF
DS1096-121A