Draining The Water Tank - Beko DC 7230 BX1 Bedienungsanleitung

6.3 Draining the water tank

Dampness of the laundry is removed and
condensed during drying process and the
water that arise accumulates in the water tank.
Drain the water tank after each drying cycle.
A
WARNING!
• Condensed water is not drinkable!
• Never remove the water tank when the
programme is running!
If you forget to drain the water tank, the
machine will stop during the subsequent drying
cycles when the water tank is full and the Water
Tank warning symbol will flash. If this is the
case, drain the water tank and press Start /
Pause button to resume the drying cycle.
To drain the water tank:
1. Remove the water tank in the drawer or
container carefully.
2. Drain the water in the tank.
• If there is lint accumulation in the funnel
of the water tank, clean it under running
water.
• Place the water tank into its seat.
C
NOTE
• If the direct water draining is used as an
option, there is no need to empty the
water tank.
6.4 For the condenser;
C
NOTE
• Clean the condenser after every 30
drying cycles or once a month.
40
To clean the condenser:
• Unlock the 2 condenser locks after
opening the kick plate
• Pull out the condenser.
• If a drying
process has been
carried out, open
the door of the
machine and wait
until it cools down
Clean the condenser
by applying
pressurized water with
a shower armature
and wait until the water
drains.
Place the condenser in
its housing. Fasten the
2 locks and make sure
that they are seated
securely.
Close the kick plate
cover.
Dryer / User Manual