Changing The Side Of The Door Hinge; Installation Of Lock And Key; Care And Maintenance - Klarstein HAPPY HOUR Handbuch

EN
24

CHANGING THE SIDE OF THE DOOR HINGE

Loosen the screws of the right hinge. Remove the upper and lower hinges. The following
parts are in the box:
1x Left hinge cover
2x hinges (top and bottom)
3x screws
Fasten the door to the appropriate position on the left side using the hinges and screws.
At the end, place the cover on the hinge.

INSTALLATION OF LOCK AND KEY

• The diameter of the lock hole is: 18 mm
• The distance between the bottom edge and the middle of the lock hole is: 62 mm.

CARE AND MAINTENANCE

Defrosting
• Frost may accumulate on the inside of the unit and defrost automatically during the
compressor cycle.
• The water is led through the drain opening into the collecting tray above the
compressor where it evaporates.
• Make sure that the drain hole is cleaned regularly so that the water can escape
from the storage compartment.
Cleaning the Unit
• Remove all shelves and the vegetable compartment. First remove the lower door
compartment so that you can remove the vegetable compartment.
• Wipe the inside of the appliance with a damp cloth and a little detergent. Then
wipe with clear, warm water.
• Wash the shelves and the vegetable compartment in water with detergent and
dry them before putting them back into the appliance. Clean the outside of the
appliance with a damp cloth.
• The condenser grille on the back of the unit and the adjacent components can be
vacuumed with a soft brush attachment.